Motorola CB200-U Resources

Get a new Motorola CB200-U on the air in a few minutes.

1. Unbox the unit and confirm all mounting hardware is present.
2. Mount the unit in its intended location following the installation guide.
3. Connect power (and network, where applicable) and wait for the status indicator to show a healthy state.
4. Complete configuration in the management portal before putting the unit into service.

The Motorola CB200-U is programmed with CB200 CPS over a Motorola programming cable.

• Install CB200 CPS on a Windows PC.
• Connect the radio with the correct programming cable for this model and power it on.
• Read the radio first so you have a working copy of its current codeplug before you change anything.
• Make your changes, then write the codeplug back to the radio.
• Clone the finished codeplug to the rest of the fleet so every radio matches.
• Because this model transmits on licensed business frequencies, the frequencies programmed into it must match those on your FCC licence.

Every radio we sell can be programmed before it ships - tell us your channel plan and the fleet arrives ready to use.

The issues we are asked about most on the Motorola CB200-U, and what to check first.

• Cannot hear the team: confirm every radio is on the same channel. A single radio left on the wrong channel is by far the most common cause.
• Short range: fit a fully charged battery, check the antenna is tight, and remember that steel, concrete and elevator shafts cut range hard.
• Short battery life: charge fully in the supplied charger. Batteries are consumable - most fleets replace them every couple of years.
• Audio muffled or distorted: clean the microphone and speaker ports and check the earpiece or speaker microphone is fully seated.
• Radio will not power on: reseat the battery and confirm the charger contacts are clean and making contact.
• Still stuck? Call our team - we support every radio we sell, for the life of the radio, at no charge.